Fall Protection

Helps prevent suspension trauma.

WARNING: This product is part of a personal fall arrest system. The user must read and follow the manufacturers instructions for each component of the system.These instructions must be provided to the user of this product. The user must read and understand these instructions before using this product. Manufacturers instructions must be followed for proper use and maintenance of this product. Alteration or misuse of this product, or failure to follow instructions may result in serious injury or death.

ANCHORAGE: The anchorage to which this product is attached must be capable of sustaining a static load in the direction applied by the personal fall arrest system of at least 3600 Ibs. With certification of a qualified person, or 5000 Ibs. without certification. When more than one personal fall arrest system is attached to the same structure, the strength requirements stated above must be multiplied by the number of personal arrest systems attached to the structure. PLAN your personal fall protection system before installing and using this equipment. Consider all factors affecting your safety during use of this equipment.

CAUTION: BEWARE OF PENDULUM SWINGS TO AVOID STRIKING AN OBJECT OR CONTACT WITH A LOWER LEVEL, FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN SERIOUS INJURY.

• Loop on one end, D-ring on the other end

Anchorage/Tie Off, 1-3/4In x 6Ft, 2 D-Ring

• Small rebar hook on one end, D-ring on the other end

Full body harness, positioning type D-ring center back and on each hip.

Chain Rebar Assembly, 22In with Large Rebar Hook

Equipment users must be trained and understand all regulatory requirements applicable to the work place in which the fall protection equipment is to be used. These instructions are not a substitute for a formal fall protection training program. Such training, should include rules and regulations applicable to the work situation, a hand-on opportunity to learn how to wear and attach equipment properly, instructions about adequate anchor points and proper techniques for securing and connecting lanyards, or lifelines, and guidance and demonstration on how to inspect and maintain the equipment.

SYSTEM REQUIREMENTS:
The ULTRA-SAFE anchor brackets are constructed to meet the OSHA/ANSI performance requirements of, anchorage connectors, for a single person, personal fall arrest and restraint systems. In accordance with these specifications the ULTRA-SAFE anchorage connectors are capable of sustaining a static tensile load of 5000 lbs. Therefore the brackets are suitable anchorage for a single person ( 400 lbs.) use all 12 pc.’s of #12 screws and stagger them 6 per side of base on 20 gauge thick metal material.This fall arrest system at 5000 lbs. (when screwed down correctly) Use all 20 pc.’s of 16d galvanized nails and stagger them to the framing member on top of sheathing. A single person fall restraint/positioning system at 3000 lbs. (when nailed down correctly) when installed and used properly.The reusable roof anchor fits any roof pitch allowing anchoring from either side.When installed in accordance with these instructions, it will provide an anchor point at the peak of the roof that is suitable for use with the ULTRA-SAFE fall arrest system. The roof peak anchor should be used in conjunction with wall planks, supported by roofing brackets, when installing conventional roofing systems on truss, rafter, and plywood sheathing constructions.

Full body harness, positioning type D-ring center back and on each hip with tongue.

• Anchorage: The anchorage to which this product is attached must be capable of sustaining a static load in the direction applied by the personal fall arrest system of at least 3600 lbs. with certification of a qualified person or 5000 lbs. without certification. When more than one personal fall arrest system is attached to the same structure, the strength requirements stated above must be multiplied by the number of personal arrest systems attached to the structure.
• Plan your personal fall protection system. Before installing and using this equipment, consider all factors affecting your safety during use of this equipment.
• Warnings and instructions must be read and understood before using equipment.
• Equipment must be used by trained personnel only.
• Users must understand all OSHA regulations, ANSI standards, and other relevant regulations and standards pertaining to fall protection equipment.