Search in Brand
Filter Your Search
Shop by Category
Search Results
Bracket for HRA65 or HRA100 Retrieval/Retractable
Bracket for HRA65 or HRA100 Retrieval/Retractable
Nylon Web Lanyard, 1In x 4Ft, Small Rebar Hooks
X-Large Ultra Pillow-Flex Iron Worker's Harness, 3 D-Ring, Quick Release Buckles
D-Ring Center Back, Quick Release Buckles with Padded Legs and X-Pad.
Screw or Nail Down Metal Reusable Roof Anchor
Equipment users must be trained and understand all regulatory requirements applicable to the work place in which the fall protection equipment is to be used. These instructions are not a substitute for a formal fall protection training program. Such training, should include rules and regulations applicable to the work situation, a hand-on opportunity to learn how to wear and attach equipment properly, instructions about adequate anchor points and proper techniques for securing and connecting lanyards, or lifelines, and guidance and demonstration on how to inspect and maintain the equipment.
SYSTEM REQUIREMENTS:
The ULTRA-SAFE anchor brackets are constructed to meet the OSHA/ANSI performance requirements of, anchorage connectors, for a single person, personal fall arrest and restraint systems. In accordance with these specifications the ULTRA-SAFE anchorage connectors are capable of sustaining a static tensile load of 5000 lbs. Therefore the brackets are suitable anchorage for a single person ( 400 lbs.) use all 12 pc.’s of #12 screws and stagger them 6 per side of base on 20 gauge thick metal material.This fall arrest system at 5000 lbs. (when screwed down correctly) Use all 20 pc.’s of 16d galvanized nails and stagger them to the framing member on top of sheathing. A single person fall restraint/positioning system at 3000 lbs. (when nailed down correctly) when installed and used properly.The reusable roof anchor fits any roof pitch allowing anchoring from either side.When installed in accordance with these instructions, it will provide an anchor point at the peak of the roof that is suitable for use with the ULTRA-SAFE fall arrest system. The roof peak anchor should be used in conjunction with wall planks, supported by roofing brackets, when installing conventional roofing systems on truss, rafter, and plywood sheathing constructions.
Anchorage/Tie Off, 1-3/4In x 16Ft, 2 D-Ring
Anchorage/Tie Off, 1-3/4In x 16Ft, 2 D-Ring
X-Large Pillow Flex Positioning Harness, 3 D-Ring, Parachute Buckles
Pillow-Flex harness and 3 D-rings with padded leg straps.
3X-Large Pillow Flex Positioning Harness, 3 D-Ring, Parachute Buckles
Pillow-Flex harness and 3 D-rings with padded leg straps.
Rope Lifeline, 5/8In x 100Ft, Double Locking Snap One End, Crown Splice Other End
Rope Lifeline, 5/8In x 100Ft, Double Locking Snap One End, Crown Splice Other End
Horizontal 60Ft Lifeline System, 2 Person Rated, Synthetic
DESCRIPTION: The US-96960 Lifeline System is designed for use as an anchoring means for up to 2 persons, used where fall protection and horizontal mobility are required. Per OSHA regulations, horizontal lifelines shall be designed, installed, and used under the supervision of a qualified person as part of a complete personal fall arrest system with a minimum safety factor of 2. Qualified person is defined as follows:
“..one who, by possession of a recognized degree, certificate, or professional standing, or who by extensive knowledge, training, and experience, has successfully demonstrated his ability to solve or resolve problems relating to the subject matter, the work, or the project.”
Refer to applicable national standards, including ANSI Z359.1, local, state and federal (OSHA 1910.66 & 1626.502) requirements, for additional information on personal fall arrest systems.
SYSTEM REQUIREMENTS: When ready to use the horizontal system, one must consider the following:
Personal Fall Protection: Use only OSHA /ANSI approved equipment.
Anchorage Points: Must be rigid and allow for a 2:1 safety factor or 5000lbs MBL.
Fall Distance: Measure the distance between working levels and lower levels, to allow adequate clearance for the system to function properly and not to come in contact with an obstruction and/or lower level. To avoid swinging or a pendulum effect, always work under your anchor point.
ALWAYS INSPECT ALL EQUIPMENT BEFORE EACH USE!!!!
10Ft Tripod, Includes 1 Pulley and 1 Carabiner
10’ Tripod Includes 1 Pulley and 1 Carabiner. Picture shows complete unit. Other parts sold separately.
NOTE: Bottom chain not required. Strength is in the head of the unit thus removing trip hazard.